Features
Included Accessories
- Removable clip
- Ring for keychain attachment
Operation
Operating your Preon 1 is simple. Make sure its batteries are
inserted with the positive side (+) toward the head. Ensure the tailcap
is tightened. To turn the Preon on, tighten the bezel (the ‘head’ of
the light) fully down. The Preon will turn on when the bezel is fully
tightened, and turn off when the bezel is loosened.
Selecting Regular Outputs
To select a different level of constant output, turn the Preon off
and then on again within 1 second. This will select the next level of
constant output in the following sequence:
Low -> Medium -> High
If the Preon is turned off for 2 seconds or longer, it will revert back to Low.
Selecting Special Outputs
The Preon has 4 special output modes: Strobe, S.O.S., Beacon (Hi),
and Beacon (Lo). To access these modes, quickly switch through two full
'cycles' of the regular outputs, starting with Low. These two full
cycles must be completed within 3 seconds:
Low -> Medium -> High -> Low -> Medium -> High -> Special Outputs
You can continue to cycle through the special outputs in the following sequence:
Strobe -> S.O.S. -> Beacon (high) -> Beacon (low)
After Beacon (Lo) mode, the output reverts back to Regular Low. Both
Beacon modes will first flash 5 times and then once every 10 seconds.
|
Specials
